Guide Handbook Manual

index» Honda » Installation manual 2010 Honda CRV-fog lamps

---

Installation manual 2010 Honda CRV-fog lamps

Honda manuals for 2010 Honda CRV Manual installation of front fog lamps.
Installation instructions for the fog-lamp:
1. make sure that you have the anti-theft codes for the navigation and audio (if available) and save the XM radio presets (if available). 2. Disconnect the negative cable from the battery. 3. remove the front bulkhead cover (seven clips). 4. remove the front bumper (four screws self-tapping, six clips and two screws). 5. remove the five clips from the left inner fender and pull down the left inner fender. 6. in order to protect the bumper used weight masking tape to the front bumper around the fog lamp left open. 7. with a knife, cut the front bumper as shown. Taken to avoid abrading the front bumper. After cutting, remove any burrs edges of the aperture. 8. from the outside of the front bumper trim, install left. 9. install fog lamp Left front bumper with four bolts self-tapping. 10. Repeat steps 6-9 thru install fog lamp right. Routing wires fog-11. Fog lights wiring routes 1-pin connector from the front inner fender as shown. Connect the 1-pin harness fog lamp to the 1-pin wiring harness of a vehicle. 12. Secure harness fog lamp to the vehicle using two wire ties. 13. Remove screw ground vehicle. Secure Terminal casing pipe fog lamp to the ground terminal of the vehicle by means of a bolt of Earth, which is that you just removed. 14. Secure harness fog lamp to the vehicle using two wire ties. 15. the Route in accordance with the ducts fog lamp projecting and secure the clip to the left of the front fog lamp, to the Panel of the vehicle.
Download