Monday, September 24, 2012
1997-2003 C5 Corvette doładowanego compressor system installation manual
C5 Corvette Compressor Installation manual doladowanego system.
Supercharger system doladowanego installation instructions:
1. Raise the vehicle on a hoist motor, using the factory recommended pick up points. You can find in the manual of manuals or shop owners for these locations. 2. remove the stock hood by disconnecting the electrical connector hood lamp, un-clipping, small gas charged shocks and remove hood screws four 13 mm socket wrench. With a cool, remove the radiator CAP and drain the coolant into the Bowl clean drain to use again later. (Be careful not to remove the radiator CAP, if the engine is hot.) 4.8 mm wrench disconnect cable to the battery negative (-). Make sure that the cable is far away from the battery, that they do not accidentally touch the batteries and make the connection during the installation. (To put the negative cable from the connector on the tape.) 5. remove the wire of air from between the throttle body and weight of airfl Ow meters. 6. remove the power steering fl uid reservoir of mounting. Temporarily place the tank on one page that will Skew and doesn't leak. 7. Disconnect throttle unit of TPS and electrical connectors, etc. 8. on the right side (passengers), disconnect the inlet manifold and two hoses of PVC vacuum supply Hose. 9. on the left (driver), unplug the power inlet manifold, brake and solenoid EVAP hoses; Leave the hose to bypass the con-nected. 10. disconnect the hoses of two of the cooling medium in the lower parts of the body of the throttle.Download
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.