Monday, September 24, 2012
1997-2000 Jaguar 4.0 LV8 engines installation methods Manual
Jaguar manuals for 1997-2000 Jaguar 4.0 LV8 engines installation methods Manual.
Installation instructions for the method:
The Committee AERATechnical offers the following information concerning the main bearing installation methods for 1997-2000 caution the Jaguar 4.0 LV8 engines. The camera uses three different screw thread sizes and improper torque is then, for some of the bolts, the lower end of the engine may result. Jaguar uses a bolts 34 possess the means of the cylinder block and there are four sizes of screws used. Method is installed, after the teams of the piston and the connector is installed and all the screws must be replaced after each use. To properly install method, follow the procedure listed below and refer to figure 1 below for locations suitable for attachment bolts. Step 1 install the "P" bolts and torque to 10-12 ft/lb step 2 installation "F" screw and torque to 18-19 ft/lbs step 3 Install "M" bolts and torque to 18-19 ft/lbs step 4 Install the "S" bolts and torque to 10-12 ft/lb step 5-6 torque, "M" screws for 25-27 ft/kg + 135 ° steps 7-8 torque's ' screws to 14-15 ft/kg + 150 ° torque step 9-10 "P" propellers to 14-15 ft/kg + 90 ° step 11-12 torque "F" screw to 14-15 ft/kg + 150 ° to complete the installation, each head screw Centre punch, after completion of the torque sequence.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.