Guide Handbook Manual

index» Ford » The System Setup Guide, 2000-2003 Ford Focus ZX3/ZX5 exhaust

---

The System Setup Guide, 2000-2003 Ford Focus ZX3/ZX5 exhaust

Ford manuals for 2000-2003 Ford Focus zx3/zx5 exhaust system setup guide.
Exhaust system: installation instructions
Remove the exhaust system: 1. using a saw or hacksaw cut stocks turning-pipe pipe Assembly just after the front silencer/front lines, as shown in Figure 1. 2. the application of cost-effective amount of spray grease to each set of installation/rubber Hanger, as shown in Figure 2, and then remove the two rear hooks with rubber mounts and pull for mounting the rear pipe/silencer from the vehicle. 3. remove the two screws securing the Assembly flange pipe muffler on the front of the catalyst. 4. remove all hooks with rubber mounts and pull the silencer pipe Assembly in front of the vehicle.The exhaust system installation: 1. place the front his new team at the flange pipe Borla performance vehicles. 2. Push the two hooks for rubber mounts and place two screws, nuts and washers, presented at the flange. Do not tighten two screws at this time. 3. place the screw end extended mounting of the silencer, and then place the mounting of the silencer pipe into the Assembly of the front, hooks the rubber push two mounts. DO NOT tighten the clamp. 4. Put a clamp on the enlarged end of the tailpipe and push the two hooks for rubber mounts. DO NOT tighten the clamp. 5. check exhaust system for proper ground clearance, and to adjust the tip. 6. once the positions of the two clamps Accuseal tighten properly between 32 to 35 ft. lbs. and two bolts securing the front pipe to the flange. 7. before you start your car, make sure you check all cables, hoses, brake lines, body parts and tyres in the safe clearance of the exhaust system. 8. Launch vehicle and check for any leaks. If the leak was found, determine the cause (eg. Clamp loose or incorrectly positioned) and repair if necessary.
Download