Wednesday, October 24, 2012
Jaguar XKE 12 cylinder Hardtop Setup Guide
Jaguar manuals for installation manual cylinder Hardtop Jaguar XKE 12.
Hardtop installation instructions:
A: before placing a Hardtop on car to: 1. fold the upper cloth into the normal position. 2. Clean the upper part of the windshield frame and rear deck area. 3. Lubricate the bottom rubber deck Hardtop with silicone grease or other suitable grease 4 remove knobs rear Velcro located directly behind the driver and front passenger seats 5 loosen the fixing on the Hardtop.
(B): Hardtop place on the car: 1. align the rear brackets on a Hardtop car mounting holes on the back. Insert the rear anchorages of the rear brackets Hardtop knobs by engaging the back of the mounting holes. Hand tighten the fasteners. 2. align the Hardtop on the windshield and install three hooks "J" in the windshield frame 3. Check the rear fasteners to make sure they are tight. 4. check the fit side for molding a Hardtop. Hardtop could be pushed forward or send backward better clearance side by removing the Hardtop and bending a rear mounting bracket in the opposite direction you want. Hardtop could be reduced by shimming rear bracket, where it installs to the hard top. 5. with a Hardtop, properly positioned and airtight Trim molding side excess.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.