Wednesday, October 24, 2012
Manual installation of Assembly 2008-2010 Ford Focus electronic Cruise
Ford manuals for 2008-2010 Ford Focus electronic trekking installation manual set.
Electronic Cruise Kit installation instructions:
A. suggestions before installation 1. It is recommended that you disconnect the negative battery cable for 3 minutes before starting the installation to avoid inadvertent airbag deployment. Note and record all the radio anti-theft code before hanging up. 2. remove the back lower driver's side and kick panels. Remove the Shroud of the steering wheel.
B. install electronic module 1. Connect the Main wiring harness, switch pedal interface wiring harness and the mating connector module Cruise Control. 3, Figure 2. Provides Cruise Control module in a secure location outside the driver's side of the line in the vicinity of the dam from the moving parts. Secure the supplied wire links. 3. Dear pipe interface pedal, steering column and the accelerator. 4. Locate the 6 pin and mate connectors on the pedal wiring interface. Remove Accelerator 6-pin mating connector and applied to the pedal interface cables. Other connector to the accelerator.
Download
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.