Wednesday, October 24, 2012
index»
Chevrolet
»
2001-2003 Chevrolet Avalanche 2500 4 × 4 6 "lift suspension Setup Guide
Chevrolet/Chevy manuals for 2001-2003 Chevrolet Avalanche 2500 4 × 4 6 "Setup Guide lift the suspension .
Lift the suspension installation instructions:
PREPARATION: 1. measure the height of the vehicle, to support their own weight of the test. The vehicle should be driven forward at least 10 feet immediately prior to this measurement to settle the suspension. The height of the Ride is the measurement from the center axis, straight up (vertical) to lip fender. Record this measurement on all four wheels on the worksheet (p. 15). These measurements will be used again after the installation is complete, you should measure the "before" and "after" in the same way.
The FRONT of the DISASSEMBLY: 1. raise the vehicle to the service manual for OE. If the worker without a hoist shop placed the vehicle in the Park, setting both the emergency and chock rear wheels, front and rear tyres. Loosen the lug nuts front wheel. Place floor jack lower front crossmember checks a well informed and to raise the vehicle, until both the front wheels are off the ground. Place the safety of Jack stands under the frame rails front wheel wells, and lower the vehicle on the grandstands. Remove the front wheels.
Download
2001-2003 Chevrolet Avalanche 2500 4 × 4 6 "lift suspension Setup Guide
Chevrolet/Chevy manuals for 2001-2003 Chevrolet Avalanche 2500 4 × 4 6 "Setup Guide lift the suspension .
Lift the suspension installation instructions:
PREPARATION: 1. measure the height of the vehicle, to support their own weight of the test. The vehicle should be driven forward at least 10 feet immediately prior to this measurement to settle the suspension. The height of the Ride is the measurement from the center axis, straight up (vertical) to lip fender. Record this measurement on all four wheels on the worksheet (p. 15). These measurements will be used again after the installation is complete, you should measure the "before" and "after" in the same way.
The FRONT of the DISASSEMBLY: 1. raise the vehicle to the service manual for OE. If the worker without a hoist shop placed the vehicle in the Park, setting both the emergency and chock rear wheels, front and rear tyres. Loosen the lug nuts front wheel. Place floor jack lower front crossmember checks a well informed and to raise the vehicle, until both the front wheels are off the ground. Place the safety of Jack stands under the frame rails front wheel wells, and lower the vehicle on the grandstands. Remove the front wheels.
Download
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.