Monday, September 24, 2012

index» » Manual installation of the 2008-2009 Chrysler 300 C, eight-channel Amp

Manual installation of the 2008-2009 Chrysler 300 C, eight-channel Amp



Chrysler manuals for 2008-2009 Chrysler 300 C Manual installation Amp eight channel.
Eight channel Amp installation instructions:
1. use the removal tool trim piece that gently Panel loose between the driver's side front door and trailing. 2. the use of that tool in Removing the Panel up to the threshold/kick Panel across the bottom of the door of the front side and remove the driver's Panel. 3. use the command remove two screws securing the screwdriver Phillips dash Panel below the steering column. One screw located next to the door opening and one across the bottom next to the hood release lever. 4. Gently lower dash Panel, pull the loose release metal fasteners. 5. disconnect the cabling for the trunk release button. (A charger and 300 C only) 6. Leave the parking brake cable connected and Swing from the side panel. 7. using a 10 mm nut driver, remove the four bolts securing the metal Panel below, the steering column, and remove. 8. push down on the fabric Panel under the dash to release two plastic connectors and delete. 9. using located, .CAL six slot, and remove the two screws securing the 10 mm metal strip on the front of the amplifier. There is one lightning bolt next to the steering column and the one next to the amplifier.
Download


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.