Monday, September 24, 2012

index» » 2006-Up Hyundai Accent Sedan, bumper, Hood, Cap, Mirror Setup Guide

2006-Up Hyundai Accent Sedan, bumper, Hood, Cap, Mirror Setup Guide



Hyundai manuals for 2006-Up Hyundai Accent Sedan , finish, bumper, Hood, Mirror Setup Guide.
Hood, finish, bumps, Mirror: installation instructions
1. spray the application area of Hood wetting agent. Remember to use liberally. 2. place the material in the hood. Line up the necessary before the squeegee. (Alignment (upper surface) is a film edge aligned to the edge of the Panel of the vehicle at a height of 2 mm +/-1 mm in parallel to the edge of the Panel within 1 mm. Alignment (areas side) is a film edge aligned to the edge of the Panel of the vehicle at 3 mm +/-1 mm.) 3. Liberally spray wetting agent surface material. This will allow the squeegee to slide on the surface of the material. 4. Align and squeegee with 3 M ™ Orange application passenger side edge of the squeegee, the squeegee should be approximately 5 cm in width. 5. squeegee Continue until hood line break, at this juncture stop and proceed to the next step.


Download


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.